2019 Chevy Blazer Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
77 Posts
Discussion Starter · #1 · (Edited)
So I had a system update. After the update now whenever I start my Blazer the Navigation SD gives me "Once initialized, this Nav SD card can only be used for navigation on this vehicle." This also causes an error on my dash that tells me about the notification and I can't see anything on the dash until I confirm the Nav.

Anyone know how to fix this or initialize the SD to my Blazer?

*Update: Figured out I had to lock the SD card. There is a little switch on the side of the SD card. Once I switched it the problem went away.
 

·
Registered
Joined
·
140 Posts
So I had a system update. After the update now whenever I start my Blazer the Navigation SD gives me "Once initialized, this Nav SD card can only be used for navigation on this vehicle." This also causes an error on my dash that tells me about the notification and I can't see anything on the dash until I confirm the Nav.

Anyone know how to fix this or initialize the SD to my Blazer?

*Update: Figured out I had to lock the SD card. There is a little switch on the side of the SD card. Once I switched it the problem went away.
Glad to hear that you fixed the problem. How did you find out that you needed to lock the SD card?
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top