2019 Chevy Blazer Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Looks like the Magnaflow exhaust is the only cat back system out there at the moment. Does anyone have one of these on their Blazer that can post some sound clips!?... There's one install video on YouTube but no real sound clips, just the vehicle leaving down a residential street. Would like to hear some Real sound clips of a cold start and some revs before spending the money on one.
 

·
Registered
Joined
·
29 Posts
I had a "Vibrant Performance" stainless axle back installed on my 2019 2LT V6. I don't recommend removing the resonater up front because the sudden change in sound when engine auto starts will be starting. The "Vibrant Performance" is the ONLY muffler out there that will fit in place of stock rear muffler on the new Blazers. The sound is low & beefy; never too much, but you always know it's there. Sounds similar to a Magnaflow, which they don't make in this configuration. One (long side) centered inlet, two end exits 2.5" diameter piping.

I had a local shop do the install because welding is required.
 

·
Registered
Joined
·
61 Posts
The "Vibrant Performance" muffler is available thru Amazon. Part number for 2019-2022 Blazer is #10633. It's polished stainless steel & looks like chrome. I've had it on about 3 years & it's holding up well. Love the sound; very pleased!
Do you have a full sound clip? Start up rev. You’ll be my determination factor lol or I’ll put some s type borlas on it
 

·
Registered
Joined
·
5 Posts
Looks like the Magnaflow exhaust is the only cat back system out there at the moment. Does anyone have one of these on their Blazer that can post some sound clips!?... There's one install video on YouTube but no real sound clips, just the vehicle leaving down a residential street. Would like to hear some Real sound clips of a cold start and some revs before spending the money on one.
 
1 - 9 of 9 Posts
Top