[OleMountainGoat]

 

[RobtRoma]

Nice! I want them too. I’ve had the vents on my last 2 vehicles and miss being able to keep the windows open a crack on hot days with a chance of rain. I’ve also had mud flaps on 3 of my last 4 vehicles. They definitely help keep the lower trim clean.

 

[Blaze20]

Those vents look good, I like how they tuck the sides instead of bubbling out like others. Could you get a shot down the side from the front side to show their profile?

 

[IceColdScotch]

I got some "points" from my dealer when I purchased my 2019 3LT last winter. I finally got around to spending them on a set of the splash guards. Easy to self-install. Took about an hour. I think it makes a significant improvement.

 

[sbubbaklein]

Ordered a set of mud guards for wife’s dark grey 1LT today

 

[2019BLAZER]

I removed the logos,rain guards added and keyless entry pad installed on the driver side.

 

[OleMountainGoat]

I removed the logos,rain guards added and keyless entry pad installed on the driver side. View attachment 756

How did you remove the logo's without marring the plastic? what did you use?

 

[2019BLAZER]

I used a old debit card to remove the letters. Then I applied goo gone with a micro sponge. Time invested? 1hr informational purposes only.

 

[Blaze20]

I used a old debit card to remove the letters. Then I applied goo gone with a micro sponge. Time invested? 1hr informational purposes only. View attachment 774 View attachment 775

I've also used fishing line to cut through the sticky tape on emblems, then use the Goo Gone

 

[2019BLAZER]

I tried using that technique, but my only issue was the amount of 3M that was left on the panel. But I totally agree with you though.

 

[Papermaker]

I removed the logos,rain guards added and keyless entry pad installed on the driver side. View attachment 756

Low profile AVS stick on?