2019 Chevy Blazer Forum banner
1 - 1 of 12 Posts

· Registered
14 Posts
The reflector is bolted from the back. The hole closest to your little finger is the bolt hole. I have attached a picture showing the bolt part number. I have also attached a picture of making it easier to get the bolt in place since you have to access it through a large hole in the bumper support. Use some duct tape and tape your socket to the socket extension. Then use some masking tape and tape the bolt to the socket. You use heavy tape on the socket and light tape on the bolt so when you pull it off when you are done, the light tape will release the bolt and your socket will not get stuck up with the bolt. I hope this helps.


1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.